Hi, I have a couple of TSUGAMI PRECISION lathes (similar to Hardinge HC chucker) that I want to convert over to CNC controls. Any recommendations on servo power needed ?? I have been looking at Keling nema34 Ac drives. I looking for for fast rapid speeds. Any input is appreciated.
Carl
Thread: Tsugami lathe conversion
Results 1 to 1 of 1
-
12-16-2010, 07:49 AM #1
Registered
- Join Date
- Nov 2010
- Posts
- 0
Tsugami lathe conversion
Reply With QuoteSimilar Threads
-
Turret Index error at Tsugami lathe
By hectorbach in forum Mori Seiki lathesReplies: 1Last Post: 12-21-2013, 10:26 AM -
Tsugami spl cnc conversion using DSPMC/ip controller
By TOTALLYRC in forum Vertical Mill, Lathe Project LogReplies: 29Last Post: 09-12-2010, 02:14 AM -
7 X 12 CNC Lathe conversion
By fragger6662000 in forum Mini LatheReplies: 2Last Post: 12-01-2009, 09:18 PM -
Ted's Tsugami Mercury NCM 45 Lathe Retrofit
By laserted in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 10-29-2009, 03:43 PM -
Tsugami PL3B Lathe start up question
By Motopsych in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 09-11-2009, 03:36 PM
Posting Permissions
