Hello, New to board and have a question on a Tsugami gang lathe with Fanuc OT control. Never operated CNC lathe before , have Bridgeport VMC with Fanuc 21 control so be gentle with me. Just bought this lathe , rigged in place today ran the power and fired it up. CRT goes through start up and "not ready" alarm stays on screen. Open the cabinet and the two servo drives show not ready status on front. My shop voltage is 213 vac and the company it came from had it wired for 240 vac. Did not know if it needs to see a home cycle to reference (like the vmc) or is it a fault in the drives or control? Got the control manual with it but no machine manual.
Any help on start up or on finding machine manual would be great.
Thanks
Jeff
Results 1 to 2 of 2
-
09-06-2009, 03:02 AM #1
Registered
- Join Date
- Sep 2009
- Posts
- 21
Tsugami PL3B Lathe start up question
-
09-11-2009, 03:36 PM #2
Registered
- Join Date
- Sep 2009
- Posts
- 21
Got it up with help from "AL The Man" and "M Controls" on another thread.
Thanks
Jeff
Reply With QuoteSimilar Threads
-
Turret Index error at Tsugami lathe
By hectorbach in forum Mori Seiki lathesReplies: 1Last Post: 12-21-2013, 10:26 AM -
Tsugami PL3B Help
By Kevin Taylor in forum CNC Swiss Screw MachinesReplies: 1Last Post: 09-06-2009, 03:10 AM -
Mini-Lathe, what to buy, where to start.
By ewest in forum Mini LatheReplies: 3Last Post: 07-29-2009, 12:37 AM -
start from lathe? fewer peoplr do cnc with lathe?
By yang_cnc in forum Benchtop MachinesReplies: 9Last Post: 06-08-2009, 01:23 AM -
Need Help lathe dont start.
By Playback in forum MetalWork DiscussionReplies: 0Last Post: 10-01-2008, 04:31 AM
Posting Permissions
