Re: Haimer Tool Offset and Z Height Problem
Try running it as Ray stated. I switched to this method and cut out nearly 99% of my height issues.
I run the Hamier down to where my (machined edge) of my part will sit and zero the DRO out. This is the same location as what I have in Fusion 360 (I measure my part thickness after the facing operation and this is what I use for stock thickness in Fusion 360). Now, this is for the second operation..... When I'm facing or decking off the part on the first operation I sometimes will use the stock top just to make it easier and to allow for variations in stock thickness.
Hope you get it dialed in. Nothing like chasing zeros + 10 to make ya go mad.
Later,
Awall
The Body Armor Dude - Andrew