[custombuilt15]

Hey all.

I have the ebay k40 using moshidraw 2014.

I am trying to figure out how to set the start position. In the output cut window I can position the laser anywhere I want over the cutting bed and that works fine. When I press output the laser moves to the top left corner hits the home switches then moves about 1.5 inches to the right and begins the cut/engrave process almost over the vent tube. I cant find any settings to tell the machine where to begin. I am new to laser engraving and the moshidraw software so I must just be missing something right?

Here is a video of a square I have made in moshidraw 2014 and the laser engraving (laser off) in the wrong place.




Hopefully someone can point me in the right direction.
Thank you.

[jayybone]

did you happen to get this figured out? i am having the same issue.