Hi all
I am nearing the completion of my CNC router build.
I am going to use Linux CNC and Leadshine Easy Servos.

Can someone out there help me out with some initial configuration settings and micro stepping settings using this setup.
Leadshine ES-D808 easy servo controller & ES-M23480 8.0 Nm stepper motor with integrated 1,000-line incremental encoder.

I have read through quite a few posts here but not found what I am looking for and thought someone might know of or have the same setup as me.
I will post this question on the CNC Zone Leadshine forum aswell.

Thanks in advance
Philip