[mrsammy]

Hi Guys,

I am quiet new using Solidworks and doesn't have formal training. I learn it by myself.
Now I'm stumble upon a problem of creating some sort of variable radius on my part.

I attached 2 files, 1 is .dwg file and the other is solidworks part file.
On .dwg file , I have 3 colors of entities. :
Red is to be R8, Blue is to be R3 and Yellow is to be a progression radius.

Hope you guys can help me with this, and please forgive my bad english.
Thanks in advance

Best regards,
David Saimi Sulong
Malaysia

[Mike 1948]

A variable radius will not work where there is a partial radius. You will need to do a cut-loft I think. Create your different profiles at the start and stop of the different radiuses and use the corner edge as a guide curve. See the help menu.

Good Luck
Mike

[mrsammy]

Mr Mike,

Thanks a lot sir for your prompt reply. I will certainly try it later.
I'm very lucky to stumble upon this very useful website, and lucky enough to received reply from a good people like yourself.
It's inspired me to share with others. Above all, sharing is caring.

Thanks again sir.

Best regards
David Saimi Sulong