I have some small (.200 diameter) parts to turn out of 17-4 PH. I've never ran this material before, and am unsure where to start.( feeds, speeds, things to be wary of?) This is on a citizen swiss lathe, with coated carbide tooling and flood oil.
thanks in advance!!
Thread: Turning 17-4 PH?
Results 1 to 4 of 4
-
06-09-2008, 08:52 PM #1
Registered
- Join Date
- Aug 2007
- Posts
- 105
Turning 17-4 PH?
-
06-09-2008, 09:19 PM #2
Registered
- Join Date
- Dec 2007
- Posts
- 617
----------------
Can't Fix Stupid
-
06-09-2008, 09:32 PM #3
Registered
- Join Date
- Aug 2007
- Posts
- 105
haha
haha!!
I totally just found that page like 5 minutes after posting this!
thanks though!
-
12-18-2014, 01:56 PM #4
Registered
- Join Date
- Jan 2005
- Posts
- 46
Re: Turning 17-4 PH?
2500 rpm feed of .001 ipr?
Reply With QuoteSimilar Threads
-
od turning
By Jimmie D. in forum Haas LathesReplies: 6Last Post: 09-04-2012, 05:07 PM -
Pinch turning or Balanced turning
By pradeep in forum Mori Seiki lathesReplies: 6Last Post: 09-07-2010, 07:55 PM -
turning O1
By grf in forum MetalWork DiscussionReplies: 9Last Post: 02-19-2010, 11:18 AM -
304 SS Turning Job
By JMFabrications in forum Employment OpportunityReplies: 3Last Post: 11-07-2008, 05:01 PM -
Turning Cam
By Regnar in forum Uncategorised CAM DiscussionReplies: 2Last Post: 04-29-2008, 10:27 PM
Posting Permissions
