[Selimsalim]

Hi,
My machine Awea 18 imb and we cutting always finish cutting no more heavy cutting,

Some time operator wrong write the program machine not stopede, tool broken but machine not stopped

I think on the screen spindle load meter

witth the macro read spindle load meter for example
If spindle load meter upper than %20 machine stopped is it possible?

[jamesweed]

i might be wrong but i don't think there is a readable parameter assigned to the spindle load meter. would be nice if there was.

here is a link to a old thread about this same subject...

http://www.cnczone.com/forums/showthread.php?t=35166

[Selimsalim]

Thank your interesting

I was checked Spindle Prm For Fanuc 18imb;
-4025 Tork limit prm

How can used this prm for loading alarm ?

My İdea=
I found it G70,4 Signal according to Prm 4025 Flickering signal

Means:
If Prm 4025 %20 loading Machine Generated G70.4 Flickering signal
My be I will used This signal on ladder give me EMG alarm is it possible?

[jamesweed]

macro b gives you 2 options;

#3000=101(ALARM MESSAGE HERE)
this will alarm out the control just like any control alarm.

#3006=1(MESSAGE HERE)
this will create a message but will not create alarm condition.

[jamesweed]

might want to look at PARAMETERS OF TROUBLE DIAGNOSIS

[Selimsalim]

Alarm is okey

machine stoped I used F45,6

Thanks

[hartan]

We can anyone explain with an example? I do not understand how it works. I have a similar problem ...

I have two tools. In the event of breakage of the first tools (standard 8mm cutter), destroyed the following tools that cost a lot of money.


When milling in full the first tool spindle load is 7%.
If power on the machine spindle milling in a specific area dropped below a certain value (for exsample 5%), this would be recorded in a parameter.
Before changing tools should always check the state of a parameter. If it was less than the predicted value, then stopped and show the message (for exsample: "TOOL IS BROOKEN").

It is that Possible?