NEW! H2 Compact (All-in-One) Controller!


H2 Compact Controller is the 4D CNC controller of H2 PCB, which is a case-mounted, ready-made complete controller with power supply unit and active cooling system. All of its specifications and adjustments are the same as those of the PCB version. This is a real all-in-one type controller.

Main technical features:

- Step/Dir system, controlled through the LPT port, stepping motor controller,
- 4D (with 4 motors), compact build-up,
- 2-phase, bipolar, micro-step motor control,
- Micro-step values, selected by jumpers: 1; 1/2; 1/8; 1/16,
- Power-output with maximum 3.5A DC for each motor,
- Mixed mode current decay with PWM regulation,
- Motor Power: 160VA, 30V DC,
- Silent holding path operating mode,
- Maximum 100kHz stepping frequency,
- Software controllable motor-rest,
- 4-range, jumperable, motor current regulation,
- 5 input ports (prepared to use end position and digitallable switches),
- 1 relay output (one-pole, maximum load 230V, 3A),
- 2-bit TTL expansion port,
- Build-up that needs only one power supply voltage (with integrated switching digital power supply),
- Protection against overheating,
- Installed Fan cooling,
- Two-sided, partly SMD PCB

CNC control softwares that can be used:

- Mach3 CNC (Win2000, XP) [recommended],
- TurboCNC (DOS),
- WinPC-NC (XP),
- CNCGraf (DOS),
- JediCut,
- GMFC,
- CeNeCe,
- Stealth Plane Works: FoamCutter,
- etc.



http://www.hobbycnc.hu