[SScnc]

Hi Guys,

I'm getting my X2 setup to also mill PCB's and I'm using Eagle Lite and the pcb-gcode ulp.

I've got my circuit schematic and board done and when I test run it in the Mach3 window (window only now) the traces and pads appear to mill perfectly. But, when I switch to the bd.nc file instead of showing the holes being drilled in the correct locations and pattern they are nothing like the board design and pad locations.

I need some help and advice to get past this step please.

Thanks for any help,

Steve

[SScnc]

Maybe this seismograph pattern is correct after all. But the Z axis never moves on G82 routines.

Has anyone else experienced this problem with G82 with pcb-gcode ?

Or have any ideas at all ?

Thanks

[SScnc]

Please disregard all that in the previous 2 posts, the pattern is correct and I update pcb-gcode from 3.3.2 to 3.3.3 and everything's working great !

Steve