[OlmsteadWorkshop]

Greetings brand spanking new here hoping you guys might be able to help me out. I set up a new vfd and spindle using Mactec54's settings below:

Huanyang 110v 2.2Kw vfd huanyang 110v 2.2Kw WC spindle.

After initial setup when I press run the spindle starts automatically and after a few seconds will display AoA then EoAA and stop.

The spindle pin 4 is grounded and continuity tests positive between the pin and the body.

I soldered the cable myself. It is a double shielded 16/4 wire and I have a drain wire connected to the green ground in the 16/4. Continuity was tested end to end.

Checked resistance on the spindle pins. Tested 0, 0, and .2

I'm a bit at a loss and hoping the folks here might be able to point me in the right direction.

My wiring is attached:
Input power 110v wired to R T and Ground
Spindle is UVW and has the 16/4 ground and drain wire connected to the same(only?) Ground as the input power.





Huanyang Mactec54
PD000=0 for Parameter unlock ( 1 ) for Parameter Lock

PD001=0 (1 For Remote Control)

PD002=0

PD003=400

PD004=400

PD005=400

PD007=20

PD008=220

PD009=15

PD010=8

PD011=120 (Minimum Setting 120)

PD13= 08 is for Factory reset, Only use this to set VFD to Factory Default Settings

PD014 Accel=12 ( Adjust to suit)

PD015 Deccl=12 (Adjust to suit) ( PD15 is ignored IF PD26=1 Then the Spindle will Coast to a Stop)

PD141=220 ( Motor Rated Voltage ) (120 for VFD Rated for 120v )

PD142=9 ( Motor Max Amps) (Set for your motor Amp Rating 2.2Kw Spindle 9 amp Max)

(Set for your motor Amp Rating 1.5Kw Spindle 7 amp Max)

PD143=2 ( Motor Number of Poles)

PD144=3000 (Max Motor RPM) =3,000= (24,000)

PD002=1 ( For Remote Pot use )

PD70=0

PD72=400

PD73=120