Can you post Report files from both controls, and tell on which feed hold stops the spindle, and on which it does not?
On most Centroid controls (i.e. all with typical PLC programming), Feed Hold is not supposed to stop the spindle. It is only supposed to stop programmed axis motion.
Results 1 to 3 of 3
Hybrid View
-
03-05-2020, 07:06 PM #1
Registered
- Join Date
- Feb 2008
- Posts
- 280
Re: Feed hold acting different on 2 nearly identical mills.
Reply With QuoteSimilar Threads
-
Adapter for 1/2" router to hold small end mills
By prestondocks in forum DIY CNC Router Table MachinesReplies: 8Last Post: 06-29-2011, 11:30 PM -
Feed Hold
By HelicopterJohn in forum Haas MillsReplies: 10Last Post: 04-25-2008, 03:57 AM -
1/16th inch mills how to hold?
By Trainhound in forum DIY CNC Router Table MachinesReplies: 1Last Post: 06-20-2007, 02:18 AM -
Stop or Feed Hold Key
By rweatherly in forum Mach MillReplies: 13Last Post: 11-12-2006, 08:28 PM -
What should Feed Hold actually be??
By REVCAM_Bob in forum Servo Motors / DrivesReplies: 4Last Post: 01-22-2006, 07:04 PM
Tags for this Thread
Posting Permissions
