Hi All, My machine is a Kitamura Mycenter 2, with Fanuc OM-B controls.

I have an issue/question with work offsets. I have 6 offsets, 00, 01, 02, etc to 05.

From what Ive been told, there is not access to G53, instead it would be G92 instead. I dont like this system. I have another machine running Mach3, and it will show me a comparison of the machine coordinates, and the offset amount from those coordinates.

So heres my main question. Most of my parts are programmed to origin X0, Y0, Z0. If I go into the work offsets page, most of the offsets still read, 0, 0, 0. If I jog down to my work, and in Offset 01 (G55), I will type in X2.0, Y2.0, Z2.0, then type back in X0.0, Y0.0, Z0.0 just to make sure that the "machine coordinates offset" is actually changed in the system memory. Since this is the OM-B controls, is there a way to actually see the offset amounts from machine "0". Ive heard there are variables or parameters that say "g54 X is #### from G28 X0.0"

Thanks in advance!!