Al,

I own 'BobCAD-CAM for Solidworks V2.' I have been exploring its capabilities for the last week or so. I am a reasonably good CATIA driver and current on 'Advanced Surface Machining.'

My question:

Look at the image I attached and you will see I need to be able to use a stock which is not a simple extrusion. I need to be able to utilize a stock that is made of multiple pieces. I am NOT proficient in SolidWorks, but I am learning. How do I use this type of stock in BobCAD-CAM for Solidworks, V2?

Regards,
Joe T.