You could make a motorized spindle for a DIY lathe or mill.That requires precise ID bearing bores in alignment with other surface geometries. The spindle shaft requires the same degree of precision for the bearing seat OD's. Now you'll be dealing with microns (.000039") for bearing fits. Then you'll have experience in precision machining.LOL
Dick Z
Results 1 to 6 of 6
Threaded View
-
09-15-2014, 06:54 PM #5
Registered
- Join Date
- Mar 2006
- Posts
- 2712
Re: would like to get into precision machining..whats a good project?
DZASTR
Reply With QuoteSimilar Threads
-
Whats a good cnc router
By cnc metalcraft in forum Commercial CNC Wood RoutersReplies: 4Last Post: 08-06-2013, 01:58 AM -
whats a good lathe to buy?
By superrican in forum Uncategorised MetalWorking MachinesReplies: 5Last Post: 03-14-2013, 04:03 AM -
Whats a good spinndle motor to use?
By tommee10533 in forum Taig Mills / LathesReplies: 1Last Post: 05-10-2009, 11:48 PM -
Whats a good way to keep dust out of my transmission screws?
By OneAndy in forum DIY CNC Router Table MachinesReplies: 8Last Post: 11-07-2008, 04:44 PM -
Whats a good book on using a lathe
By TheGreenMachine in forum MetalWork DiscussionReplies: 4Last Post: 03-27-2008, 03:46 AM
Tags for this Thread
Posting Permissions
