Hello...
When i want to move to the tool change position, the machine want to move 101mm over the home position...
What parameters change the Tool change Position?
greetings from Germany,
Peter
Hello...
When i want to move to the tool change position, the machine want to move 101mm over the home position...
What parameters change the Tool change Position?
greetings from Germany,
Peter
My guess would be to check your tool change macro program, assuming your machine has always had this problem.
where can i open it?
I think Mazak T32 is with Mitsubishi 300 controls, so there is an edit lock B (that's the data protect key that is on your operator panel) and edit lock C (param 39 of basic specifications is set to 0). Then you should be able to open your O9000-O9999 macro programs, usually O9001 is the one used for tool change.
Hello Friend,
The tool change position is decided by the parameter P17 and you can set from 1 to 8 depending on your requirement and before doing any changes always note down the original value and do.Refer the parameter manual for description of each setting say 1------meaning,2-------------meaning.
SHEKAR
So.. it fix or not?