The M41 did not change anything.
I just checked the overload on the spindle contactor and it is ok.
I checked the thermal switch on the DC motor and it is ok.
The spindle will not do anything either by the operators panel or the MDI. The only thing that shows anything is the spindle meter that reads that it is at 100%. Also when the machine is on it makes a high pitched whine when you rotate the spindle but absolutely no motion. This is a DC spindle unit with 2 Honda plugs so I am assuming this is a binary unit based on some previous reading here on the forum.
Does anyone have a manual and or schematics for this unit? It sure would help diagnose this thing if I understood how everything is supposed to work together.

One other thing. Based on some reading on the forum. Someone previously said that parameter 003 should be 00001000 for digital or 00010000 for analog drive unit. My parameter 003 is 00000000. I don't know if this info is correct for a 6T but I thought I would throw that out there. I did change the parameter but nothing happened.