[gus]

MP 44 : +457,327 [x limit]

MP 45 : -1,270 [x limit]

MP 46 : +304,928 [y limit]

MP 47 : +0,000 [y limit]

MP 48 : +2,000 [z limit]

MP 49 : -127,127 [z limit]

from the parameter lists on this site

[BooherCNC]

Thanks Gus, I am not sure what I did to the Z axis. I was only working what I believed to be in the X and Y. I can run the X and Y axis to the mechanical stops + and -. At the moment the spindle is approx. .250 to the negative and will not come any lower. Soft limit warning comes on screen. Thanks for the parameters. I down loaded a few from the site and here is what I have. The information above from you, and 151parafunc from this site says, MP44 +1,000, MP45 -400,000 MP 46 +300,000, MP47 -1,000, MP48 +1,000 and MP49-100,000. The 151para also down loaded from this site say, MP44 +8,000, MP45 -440,000, MP46 +0,000, MP47 -295,000, MP48 +0,000, MP49 -119,000. I also downloaded a third one MP44 +8.100, MP45-449.000, MP46 6.200, MP47 -298.900, MP48 +8.300 and MP49 -116.800. So if we compare just on parameter MP44. I have +457.327, +1,000, +8,000 and +8.100. You can see where I am having trouble wrapping my head around this. On my Mach 3 I hit Ref all home, she homes and am ready to zero the bit on the part and make chips. I will be back in the shop on Saturday and will compare your parameters to what is in the machine and plug your numbers in and see if I can tweak it. Thanks again. Mike B.