Hi everyone,
I'm looking for some help with some unpublished specs for the X3 mills.
I have a project in mind for my X2 that includes a stand alone milling table, but the table top has some problems. I'm thinking I may be able to fit an X3 table if some of the specs are close enough to the new saddle I'm using.
What I need to know is:
- Dovetail angle -
- Dovetail height -
- Dovetail width - (Measured across .250" or .375" dowel pins)
I appreciate it if any X3 or SX3 owners could help me out with this