I need a parameter because I loat all parmtr of machine I have no back of this please send me on [email protected]
Best regards,
Jayavant
I need a parameter because I loat all parmtr of machine I have no back of this please send me on [email protected]
Best regards,
Jayavant
Torrent might not getting indexing signal due to following reasons:-
1. Sensing tenet on back side of turret might be loose due to which it is not getting stop signal.
2. Or it might be due to sensor signal drop for some wiring related reason or loose wiring.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Hi, I have a Jonhford TC20 with a control Fanuc 0-T, the problem with the turret is that it indexes well manually, but lately when running a program we realized that the turret kept turning and keeps moving as if it were in the correct position, if you could provide me your parameters to see if that solves my problem or any advice to follow, best regards.
e-Mail: [email protected]
Good day,
I seem to have exactly the same problem. I would appreciate it if anyone can help me and send me all the correct parameter & diagnostic settings to [email protected]
Thank you,
I have a similar problem with my ZL15-S, Fanuc 0-T B. I need to reset the machine parameters. When resetting the machine, the default is MDI mode, I can't change to EDIT. When I manually enter parameter 905, the machine blocks me from editing the other parameters.
Maybe someone of you has already encountered this problem and could help.
show us the complete 905 parameter,i think you put a bit that is not supposed to be enabled
Hi,
The list of parameters in the attachment.