Most noise from spindle motors is down to balancing, if the spindle and tool is perfectly balanced, including the collet nut, then noise should be to a minimum,
Thread: Spindle thought
Results 1 to 15 of 15
Hybrid View
-
05-28-2012, 05:32 PM #1
Registered
- Join Date
- Dec 2010
- Posts
- 33
Spindle Idea
Ex Emach Service Engineer, contact me for assistance.
Reply With QuoteSimilar Threads
-
Just thought we'd say hello
By Valen in forum Australia, New Zealand Club HouseReplies: 3Last Post: 08-01-2010, 11:41 AM -
Modified X2 Spindle thought.
By BSawyer486 in forum Benchtop MachinesReplies: 6Last Post: 06-01-2010, 03:33 AM -
15 Min left, thought I'd point out this spindle!
By Hdale85 in forum DIY CNC Router Table MachinesReplies: 2Last Post: 10-03-2009, 01:17 AM -
Thought I better say Hello
By Nigel_B in forum Australia, New Zealand Club HouseReplies: 0Last Post: 09-06-2006, 12:50 PM -
Cheap spindle thought
By Hobbiest in forum DIY CNC Router Table MachinesReplies: 19Last Post: 07-08-2004, 02:48 AM
Posting Permissions
