Hi dbrija:

Rarely do my holes ever come out too deep. They mainly do just the opposite; to shallow.

I've watched a video about the feature you eluded to. I new that I could use it to cut through the bottom surface of my work piece.

I was just wanting to figure out how to enter the correct numbers in the first place so as not to have to rely on that feature to fix my hole depths after the fact.

I too had forgotten exactly how to access that particular "Hole Editing" feature.

Thanks Gerry. The Screen Shots you've provided helped me a little. I'm still struggling to get all this information to click in my mind. I guess there's no getting around it; I'll just have to do some more practicing with this software.

MetalShavings