[jterrell]

I'm constructing a post in code wizard for G & L boring mill with a fanuc 31B control. All code looks great except the helical boring with a high feed mill does not post out the "Z" moves. What do I need to change in my post for this to post out.

[jtreanor]

Depending on your post settings - the helical move is output from
Code Constructors - General Motion - 2D Circular Interpolation
or
Code Constructors - General Motion - Helical Interpolation - (new constructor for controllers that support a Helical canned cycle - ie. Threadmilling)
Older Posts it was in
Code Constructors - General Motion - Circular Interpolation CLW
Code Constructors - General Motion - Circular Interpolation CCLW

The Z value is typically set as Modal - (only output when changed)
use "Force Output Now" to override the modal setting in a specific constructor.

[DELETE][BLKNUM][PLANEGCODE][<C>CLWGCODE][<C>XARCEND][<C>YARCEND][<C>ZARCEND][<C>IVALUE][<C>JVALUE][<C>KVALUE][<C>ARCRADIUS]