[shred]

I have one that works but it is rather heavily edited to match my machining style. The Mach one (which it started as) with a few tweaks to get rid of bad code generated I hear works pretty well if you're used to that.

[keen]

I have one that works but it is rather heavily edited to match my machining style. The Mach one (which it started as) with a few tweaks to get rid of bad code generated I hear works pretty well if you're used to that.

Hi Shred - if it works well for you it probably will for me. I have installed the latest version of PathPilot .

So I tried to run a simple previous code ex BCC V25 ex my previous Mach3 Post P. Error messages one after the other....Damn!

....it is a pain because I just want to get on with learning and using Pathpilot.

So, if you have time... I would be keen to try your Post P.... keen

[bevinp]

I have one that works but it is rather heavily edited to match my machining style. The Mach one (which it started as) with a few tweaks to get rid of bad code generated I hear works pretty well if you're used to that.

Shred,
Is the file you modified "postMach3Mill.pst"?
Bevin