I will get the total and P.M. you.
today, or tomorrow AM.
Al.
Results 1 to 20 of 30
Threaded View
-
04-14-2014, 11:38 PM #13
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24223
Re: CNC Spindle motor power wire type and sheilding from other wires?
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With QuoteSimilar Threads
-
Wire type/gauge, power supply to G540?
By remskm in forum Gecko DrivesReplies: 4Last Post: 02-20-2013, 05:18 PM -
Wire type/gauge, power supply to G540?
By remskm in forum DIY CNC Router Table MachinesReplies: 1Last Post: 02-20-2013, 05:41 AM -
6 Wire Motor-4 wires to controller
By Gallchobhair in forum Stepper Motors / DrivesReplies: 2Last Post: 09-14-2012, 04:08 PM -
Mitsubishi 90c wire edm - where do these wires go ?
By BACKFIRE in forum CNC Machine Related ElectronicsReplies: 1Last Post: 11-15-2008, 02:37 AM -
Mitsubishi 90c wire edm - where do these wires go
By BACKFIRE in forum EDM Discussion General TopicsReplies: 0Last Post: 11-15-2008, 01:50 AM
Tags for this Thread
cable,
chain,
changer,
closed loop,
cnc,
cnczone,
drive,
electrical,
electronics,
encoder,
lathe,
machine,
manual,
mill,
motor,
power,
project,
rebuild,
retrofit,
spindle,
spindle motor,
tc-22,
tool,
tool changer,
wiring
Posting Permissions
