[OT-CNC]

Hi

On the motor configuration page on pncconfig there is a stepper info configuration section. What values do I need to enter that are specific to the DMM DYN3 drives? This is for the Step On-Time, Step Space, Direction Hold and Direction Setup. They have a few different default settings to pick from or custom numbers I can enter. What is correct for my drives when I use
them in step/dir mode? I'm also using MESA 5i25, 7i85s and 7i84 for stepping,i/o's and encoder feedback.
Here is a link to the stepgen section:STEPGEN
All I see in the DMM manual is Pulse Train Specifications: T is greater or equal to 2us.
I'm also not sure what units I'm working in on that stepper info screen.
I'd like to get this correct before working on the other issues...

Thanks!

[OT-CNC]

Meant to add that I'm using ver7 on Linuxcnc.

[OT-CNC]

Maybe it's easier to figure out what the corresponding values are in the final ini file. Can someone look into their ini file and share those numbers?

[OT-CNC]

80+ views and no one knows? No one else here runs these on Linuxcnc??
I will ask over at Linuxcnc.

[OT-CNC]

The discussion can be found here:
http://www.cnczone.com/forums/linuxc...-settings.html