Hi Heli Bee,
I have just imported your stl file into EdgeCam and produced the attached gcode. I have used the same feeds as you have and used a 20mm diameter end mill for the roughing cut and a 3mm ball nose for the finishing cut. Your original post said you used a 10mm radius cutter for roughing but did not say whether it was a ball nose or not. If you want me to change it, I can.
Hope this helps,
Mike
PS The attached file was a .rar not a .zip but the zone would not accept the .rar extension.
Thread: Ripples in my moulds
Results 1 to 20 of 30
Threaded View
-
12-29-2010, 06:18 PM #22
Registered
- Join Date
- Aug 2003
- Posts
- 454
Reply With QuoteSimilar Threads
-
Injection Moulds
By jatinderr in forum News AnnouncementsReplies: 1Last Post: 12-03-2009, 06:39 AM -
x3 for 3d moulds?
By nicrump in forum Syil ProductsReplies: 2Last Post: 12-29-2006, 03:09 PM -
Pictures of your Moulds
By MBG in forum Casting MetalsReplies: 15Last Post: 11-05-2006, 12:37 AM -
Router for 3D moulds
By erazz in forum Commercial CNC Wood RoutersReplies: 3Last Post: 10-23-2006, 07:32 PM
Posting Permissions
