The BOB is between the smoothstepper and the xylotex. I'm measuring the scope traces from the BOB however where it goes directly to the xylotex. So I'm seeing the exact pulses as they are being input into the xylotex.
Thread: Stepper Motor "cogging" issue
Results 1 to 19 of 19
Threaded View
-
05-08-2009, 03:40 AM #17
Registered
- Join Date
- Jan 2007
- Posts
- 435
Reply With QuoteSimilar Threads
-
what is to "slave" a stepper motor?
By salvaCNC in forum Stepper Motors / DrivesReplies: 10Last Post: 12-03-2007, 10:41 PM -
"Astrosyn Miniangle Stepper" Power Drive
By hferraz in forum Stepper Motors / DrivesReplies: 0Last Post: 10-31-2007, 09:27 PM -
Help finding information on Sanyo Denki "Step Syn" IBM stepper motor
By Oracle_9 in forum Stepper Motors / DrivesReplies: 12Last Post: 06-08-2007, 06:55 PM -
nude pictures of Jessica Alba (Best "cost is not an issue" software)
By sundy58 in forum CNC (Mill / Lathe) Control Software (NC)Replies: 20Last Post: 04-23-2006, 06:51 AM
Posting Permissions
