[leeko]

I understand yuu use Fusion 360 from previous posts. Did you fill out the comment line in the Post Processor section of the tool library? That sould show up on your screen when a tool change is called.

You can also print out the setup sheet which will list out all the tools in order by operation and with parameters.

RT

Thanks RT, I'll take a look at the comment line

I did think about printing out setup sheets as a workaround, but was hoping to avoid having to do that for every job - I don't run production, so it's just an extra step every time. I figured I was missing some basic function... Seems a bit weird that it's not possible to see the code...

Lee