...
...
I was finally able to get back on my machine last night. It was a bit cooler at about 80° F.
I was able to run all my NC programs with only one USB disconnect. I plugged the USB cable end into another USB port on the laptop and did not experience any more USB disconnect errors.
I also put my following error settings back to 60 for all three exist without any following errors.
.................................
On another subject:
I cannot seem to get the G43 Hxx working. I am expecting when I use the G43 Hxx in KmotionCNC I should be able to change the tool gauge length with the tool data "Length"; however, I get no response from the following.
Here is an image of the Tool-Data table:
Attachment 425010
Here is the NC Code I am trying to run with tool length compensation:
G40 G90
G20
( PATH NAME : FIN_CENTER_HOLE WITH TOOL NO: 2 )
( TOOL NAME : CEM_.250XR0X4FLTS TOOL CATALOG NO. NONE ENTERED )
( Tool Number: 2 )
( Tool Name : CEM_.250XR0X4FLTS Tool Diameter: 0.2500 Tool Length: 3.0000 )
N10 M00
N20 T02 M06
N30 G00 X-.275 Y.1 S3499 M03
N40 G00 Z.52 G43 H02 M08
N50 G00 Z.12
N60 G01 G94 Z.02 F12.
N70 G03 X-.375 Y0.0 I0.0 J-.1
N80 G03 X0.0 Y-.375 I.375 J0.0
N90 G03 X.375 Y0.0 I0.0 J.375
N100 G03 X0.0 Y.375 I-.375 J0.0
N110 G03 X-.375 Y0.0 I0.0 J-.375
N120 G03 X-.275 Y-.1 I.1 J0.0
N130 G01 Z.12
N140 G00 Z.52
N150 M05 M09
N160 M30
I would expect line N40 of the NC code above to offset the tool #2 up by 1.0" ... the actual tool position should be Z1.52 after it executes NC line code N40.
What am I missing here that it is not working in KMotionCNC?
Thanks,
...
.....