I am having the same issue with a Fanuc 32i-Model A

If I add the WO on my N1 line it will make an extra pass for no reason.
If i remove the WO from N1 line. Tool path runs fine except it will leave steps on my angles and clean them up on the last pass.
I'd rather run it with no steps but i'm having the repeat last pass issue.

Any help on fixing this would be greatly appreciated.

G0X6.45Z.15T0101
M8
Z.0366
G96S600
G71U.2R.025
G71P1Q2U.02W.005F.016
N1G1X3.9701W0
Z.0316F.016
X4.1717Z-.0692
G3X4.19Z-.0912R.0313
G1Z-1.0783
X4.5017Z-1.2342
G3X4.52Z-1.2562R.0313
G1Z-4.1
N2X6.45
G0
Z.15M5