[hub]

I set it to 50us just in case the feed was faster and so not to miss a trigger. Changing this seems to only alter the delay that it is waiting for a signal to be passed to the controller. Adding a second instance did nothing.

The 50us was a typo, sorry I meant 50ms. like you had it, It won't change much. It's just there to reduce CPU processing.

Did you remove the activateSignal(ENABLE1) from the While loop, and set it after the last "Wend"?

Hub

[vangalvin]

The 50us was a typo, sorry I meant 50ms. like you had it, It won't change much. It's just there to reduce CPU processing.

Did you remove the activateSignal(ENABLE1) from the While loop, and set it after the last "Wend"?

Hub

I increased the Sleep to 100 and removed the enable but did not make any difference, Its as if it is not counting the clicks from the input or calculating how many are required for the material to be in position for the next pass.