I had version 3.043.067 installed in the Pulsar and found that it would not home the machine correctly.Then I installed version 3.043.022. It homed okay, but would not run the spindle.
Then I tried 3.043.066. It does everything correctly. Apparently some have issues with that version, but I cannot find any fault with it.
Thread: LinuxCNC?
Results 1 to 20 of 80
Threaded View
-
01-08-2015, 09:09 AM #10
Gold Member
- Join Date
- Jun 2004
- Posts
- 6618
Re: LinuxCNC?
Lee
Reply With QuoteSimilar Threads
-
Linuxcnc 2.6.0 is out.
By samco in forum LinuxCNC (formerly EMC2)Replies: 1Last Post: 07-30-2014, 03:13 PM -
Linuxcnc 2.5.2 won't run
By cpeter in forum LinuxCNC (formerly EMC2)Replies: 18Last Post: 04-24-2014, 12:54 PM -
LinuxCNC capabilities?
By AtomicCNC in forum LinuxCNC (formerly EMC2)Replies: 1Last Post: 03-28-2014, 10:50 PM -
Linuxcnc coolness
By samco in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 07-19-2012, 05:05 PM -
LinuxCNC right for me?
By punisher454 in forum LinuxCNC (formerly EMC2)Replies: 10Last Post: 06-18-2012, 04:56 AM
Tags for this Thread
Posting Permissions
