So when you open the door the coolant is going to run down the right side of the machine and drip all over the floor?
Maybe there is a channel at the bottom of the door? I guess I will still buy it since you have to for the tool changer..
So when you open the door the coolant is going to run down the right side of the machine and drip all over the floor?
Maybe there is a channel at the bottom of the door? I guess I will still buy it since you have to for the tool changer..
Maybe there is a piece of rubber that acts like a squeegee to strip the coolant off the door as you slide it open?
If not, seems like it would be easy to add.
Tim
Tormach 1100-3, Grizzly G0709 lathe, Clausing 8520 mill, SolidWorks, HSMWorks.