[ahren]

Regardless of where you purchase your electronics, for a rack and pinion based system you will almost certainly want to drive the gantry with a motor on both sides. This helps avoid racking, and puts more power behind the largest moving mass on your system. So I'd make sure you're looking at 4 axis electronics kits.

Best regards,

Ahren
CNCRouterParts

[svfrolic]

Regardless of where you purchase your electronics, for a rack and pinion based system you will almost certainly want to drive the gantry with a motor on both sides. This helps avoid racking, and puts more power behind the largest moving mass on your system. So I'd make sure you're looking at 4 axis electronics kits.
CNCRouterParts

That's what I thought. I saw other people using four motor kit for r&p routers. It's just something that vendor recommended so I thought I would ask about these motors.
I was checking your website and I was going to send you an email asking about some components for my machine. I just need to make a drawing so I can explain better what I need. I plan to weld my machine from steel instead using extrusion but I would like to use some of the hardware you sell such as linear motion parts, motor mounts etc.
Now I am trying to figure out what would be good electronics kit for the machine.