Upload a picture of the control panel to refresh the memory.
Upload a picture of the control panel to refresh the memory.
Some a little blurry, but let me know if good enough. And, disregard the search for the RS232 port, I found it. The cover was stuck and even broke when it finally opened.
Mike
Two Haas VF-2's, Haas HA5C, Haas HRT-9, Hardinge CHNC 1, Bother HS-300 Wire EDM, BobCAD V23, BobCAD V28
Photo 3 shows a mode select button. I would think it will show mode on screen? Once on zero return or home mode, hold the + feed buttons for each axis until to stops on home? Fanucs usually have a mode select rotary switch. It has been over 14 years since I touched a Hardinge with the Seimens control. Highly recommend you contact Hardinge. They have always helped me in the past, even on older machines.
Thanks for the assistance.
I ordered some seals from a Hardinge distributor and some how they messed up the order. Had them over-nighted to arrive on Saturday and one seal was missing. Lost a weekend of work on it time, but talked them into going to the Hardinge site and down loading a manual for me, they have access. Just got back from Staples and having it printed out.
So, if anyone else needs one I have it now.
Thanks---Mike
Two Haas VF-2's, Haas HA5C, Haas HRT-9, Hardinge CHNC 1, Bother HS-300 Wire EDM, BobCAD V23, BobCAD V28
Did you have them save it as a PDF file?
Two Haas VF-2's, Haas HA5C, Haas HRT-9, Hardinge CHNC 1, Bother HS-300 Wire EDM, BobCAD V23, BobCAD V28
Mike
I have the same machine as you and have lost all the commissioning data due to a board shorting out.
Could I trouble you to download A copy of yours and e-mail to me ?
[email protected]
Thanks
Mark