[ihavenofish]

the drawings suggest if it failed it would flow through the spring stack or and out the back, not into the bearings. but in any case, it would be bad.

i dont have any immediate need for it so it wont get reconnected until i have a long hole to drill.

i plan on taking apart some of the cabinet today. should be an adventure.

[ihavenofish]

tired, ha.

took off the sides of the cabinet. relatively easy job all this, but the parts are pretty awkward and heavy for one person. i need a helper, haha.

ive realised though i cant take the x axis way covers off without taking the table off, so ill just be pulling them out a bit and washing them then putting them back on. shouldnt be to big a deal.

[ihavenofish]

ive made an indiegogo page to help pay for some of the refurb of this beast. not sure if any of the perks are of much interest to the cnczone members - i had debated putting benchtop mill parts as rewards, but decided to save that for later.

SnoFlake Machine Shop -- Indiegogo