401 ALARM is 'normally' caused when the Fanuc CNC isnot getting the 24 V ready signal send via the ESP switch in the PSM
402 SERVO ALARM: SV CARD NOT EXIST (sounds like the servo card is faulty)
401 ALARM is 'normally' caused when the Fanuc CNC isnot getting the 24 V ready signal send via the ESP switch in the PSM
402 SERVO ALARM: SV CARD NOT EXIST (sounds like the servo card is faulty)
************************************************** *********
*~~Darwinian Man, though well-behaved, At best is only a monkey shaved!~~*
************************************************** *********
*__________If you feel inclined to pay for the support you receive__________*
*_______Please give to charity https://www.oxfam.org.au/get-involved/_______*
************************************************** *********