[rolveram]

Hello:
Can somebody tell me if is possible to make a 3d drilling program with mastercam?. I need to drill several holes over a flat plate but all of them with different depths.
I allready have done programs with round contours in 3d, and I think that it must be easier with drilling, but I can´t do it. In the drilling toolpath menu doesn´t exist this, or I don´t know how to do it.
At present I am using the v.X3. I would appreciate any aid.
Thank you

[Superman]

You have to have selected the hole centrepoint at the finish depths --- ( you can select arc centres if needed )

op parameters
retract = 0.1 ( abs )
top of stock = 0 ( abs )
depth = 0.0 ( incre )

[rolveram]

Hello Superman:
Thank you very much for your advice. I just try today and I made my task successfully.
Regards.