[pickled]

After watching an overview of how this command works I REALLY want to upgrade to V9 soon! Have any of you used the morph command yet, because it looks like a real time saver? If you have no idea what I am talking about you can look to our favorite Russian tutorial. For those of you that have used this please tell me that it isn't buggy :-).

https://youtu.be/A3_R-CrQCqw

[Slowzuki]

I've used it and it works very good if you have the right application. It's like everything else in sprutcam though and is a little finicky but for the most part works fine once you understand how to use it. It does a better job than parallel finishing it your geometry supports it. I've used it on several die sections and it is pretty slick there. I'd guess it saved about 25% on actual machine time and but there is a slight variation on the finish as the stepover changes, never for the worse though as you define the max step over.

[pickled]

Thanks Slowzuki! My next upgrade was going to be a better heat treat process, but I might just move towards Sprut 9 first because I think that I would gain more design and operational efficiency.