Newbie here, Every time I groove I get these ridges on each side of the groove that are rough and protrude above the steel. I am cutting 316 Stainless. How do I get these to go away. Should I be sanding these out?
Results 1 to 1 of 1
-
01-29-2014, 11:08 PM #1
Registered
- Join Date
- Jul 2013
- Posts
- 6
Ridges while grooving and parting
Reply With QuoteSimilar Threads
-
Ridges in 3D work that aren't step over related
By Shinobiwan in forum Mach Software (ArtSoft software)Replies: 24Last Post: 04-15-2013, 10:42 PM -
Engraving pine leaves 'ridges' where grain is
By BlueRebel in forum Laser Engraving / Cutting Machine General TopicsReplies: 3Last Post: 02-01-2012, 12:01 AM -
ridges on spoilboard when surfacing
By Dan.antes in forum Calibration / MeasurementReplies: 8Last Post: 12-15-2009, 08:23 PM -
Mini lathe parting/grooving blade or tool with blade help
By Jaime128 in forum Mini LatheReplies: 4Last Post: 01-02-2009, 10:55 AM -
Controlling the amount of tool overshoot in parting off/grooving??
By Captdave in forum Mazak, Mitsubishi, MazatrolReplies: 4Last Post: 12-23-2008, 01:11 AM
Tags for this Thread
Posting Permissions
