I know, I can just put a - on the axis in controller setup and make the motor run in the right direction and I know that Gecko says just switch around the A and A- leads on coil A terminals 3 & 4. But I read somewhere, and now can't find it, that swapping 5 & 6 on coil B does the same thing, right or wrong??
Thanks Gecko guys. B.G.
This is a G202 Drive
Thread: Reversing Stepper - Wires
Results 1 to 3 of 3
-
11-07-2005, 03:02 PM #1
Member
- Join Date
- Sep 2005
- Posts
- 1740
Reversing Stepper - Wires
-
11-07-2005, 05:35 PM #2
Registered
- Join Date
- May 2005
- Posts
- 16
Switching wires
Switching wires on either connection a or b will do the trick. It doesn't really matter which one you switch. It is just a matter of conveniece to mention only lead A.
Greetings, Kevin
www.damencnc.nl (see the tutorial on connection steppermotors)
-
11-07-2005, 05:53 PM #3
Member
- Join Date
- Sep 2005
- Posts
- 1740
Connections and prices
You know I read that someplace else and can't find it when I needed. I know I'm being picky, but the one that runs in the right direction has B motor wires connected differant.
Why do I care, I took the connections from the old controller / drive (XYZ Pro III) and just wanted all the colors to match.
Are your prices on your website in USD? How would you ship to US? Thanks. B.G.
Reply With Quote
Posting Permissions
