[Chuck Reamer]

I have a Daewoo Lynx with a Mits M50L controller, no floppy drive just a RS232. I am trying to step it down to USB and upload/download programs on my laptop.

I have been trying with Mastercam editor and EasyDNC demo with no luck.
It says device not ready on controler when I try to download. I have a line tester hooked up and the port is working, just not downloading for me.

Does anyone do something similar and could give me any suggestions.

I have been considering getting a Calmotion disk reader or a CNCGcoder from RBR, but they are about $800.

http://www.rbrusa.com/CncGcoder/CncGcoderHD.html

http://calmotion.com/

[Chuck Reamer]

Even going Rs232 to rs232 wont work for me, is anyone doing this successfully with this controller?

[Al_The_Man]

Make sure you have the correct port identified, also use hardware handshake jumpered out, this is 4-5 & 6-8-20 on a 25p connector.
Al.

[Chuck Reamer]

ill give that a whirl, thanks Al

[KEO-MAR]

Hi,
i have a Mits M60 controller with just a RS232 port, i too have been trying to connect through to USB and up/download programs to my laptop,

i just get a E04 Device not ready,

did you ever find a solution to this problem??

thanks