Trying to engrave a fairly large logo for a client and when I import the image, the preview is correct. But after the two hours I could see that part of the text in the top right corner was not fully engraved and it straight up did not engrave at all a portion in the center. Everything else was right. Giving it another pass at a lower speed to see if that wont correct the problem Should i use another program to "clean up" the image up? I have photograv and it works wonderfully for images.. Any ideas? Trying to get this out TODAY!! Thanks guys. These forums have been very helpful and informative.
Thread: Problem with Lasercut?
Results 1 to 2 of 2
-
10-23-2014, 03:12 PM #1
Registered
- Join Date
- Oct 2014
- Posts
- 5
Problem with Lasercut?
-
10-27-2014, 05:37 PM #2
Registered
- Join Date
- Oct 2014
- Posts
- 5
Re: Problem with Lasercut?
nevermind. figured it out. no thanks to anyone on here
Reply With QuoteSimilar Threads
-
Need Help, serious problem Ryntime Error LaserCut software
By sensenku in forum Laser Engraving / Cutting Machine General TopicsReplies: 2Last Post: 08-04-2014, 10:57 AM -
Is Lasercut casuing this problem
By BuckeyenNJ in forum LaserCutReplies: 2Last Post: 05-17-2013, 11:06 PM -
Problem with lasercut 5.3 highspeed cutting
By zoefie in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 06-24-2010, 02:35 PM -
Lasercut V51 - HELP!
By TheWorkshopGuy in forum Laser Engraving / Cutting Machine General TopicsReplies: 2Last Post: 10-05-2009, 11:25 AM -
Help! LaserCut software invalid serial port problem
By terry32506 in forum DNC Problems and SolutionsReplies: 0Last Post: 07-17-2008, 06:21 PM
Tags for this Thread
Posting Permissions
