Hey ppl...

I just ordered the "MICRO Router MOF, #38 568" to use as a high speed spindle on my SX3...
It's on the Proxxon website under "New items"...

I was considering the IB/E but then I found this router which shares the same collets as the IB/E...
It's a bit faster at 27,500 rpm and slightly more powerful at 130 w...
It can also be found for less than 100$ on Ebay (new)...

I will be using this mainly for making PCBs... I also have some 0.2 mm carbide engraving bits on there way too...

If anyone is interested I will post my experience with this router regarding run-out, mounting, noise, rigidity, etc etc...

Michael