[Exodus8931]

i'm looking for a mastercam post

that will work on this machine. i take any standard post for most of programing but i run into a errors on the machine when i'm milling anything with Radius,

i tried I and J, and i tried just R.

the fu.... pice of old junk machine keeps getting errors .... i don't know what the fu... is it's problem

anyone ? please

[Superman]

I'm not going to "give" you a post (don't have one), but we ( the forum ) could "help" you to getting the post correct, and instruct you on modifying it.

#1 ---what version of Mastercam do you have ? and what machine control ?
#2 ---create a 1" circle in mastercam and interpolate the bore with a 5/8" cutter using a 2D contour -tool #1
---spotdrill 2 holes -tool #2
#3 ---post all ( use " TEST-POST" as the NC filename )
#4 ---manually modify the NC program to run correctly on the machine ( save as "TEST-MACHINE" as the filename )

After you have done this
#5 ---create a compressed ZIP folder on your desktop, and copy into it
--the MCX file
--the post you used
--the un-edited NC file from #3
--the edited NC file from #4

#6 ---on your next message, upload that compressed file as an attachment, and then we may know what your next step would be ( use the "paper clip" icon at the top of this box, browse for your ZIP folder, then upload -you may have to wait a little)

[Exodus8931]

I'm not going to "give" you a post (don't have one), but we ( the forum ) could "help" you to getting the post correct, and instruct you on modifying it.

thanks, but there is too much code to change, realy, ill be looking around to see if anyone has it.....

on a side note .... i can't belive there is only few post on the mcpost forum.... ???????? guess i'll start posting what i got....