[winkdemon]

Hi guys , i just bought a plasmacam 4x4 a couple weeks ago , i have a cutmaster 39 and a cutmaster 152. but i need a material contact sensor. wondering if any of you guys are run a thermal dynamics with you dhc2 with basic height control ? i have made a home made one but would like to get a good one if i can buy one for the units

thanks

[jimcolt]

Best bet is to call Thermal Dynamics technical service to see if they have an "ohmic" sensing retaining cap and shield for the torches you have. The Hypertherm units above 30 amps all have them....but not sure about T-D's offerings.

Jim Colt

Hi guys , i just bought a plasmacam 4x4 a couple weeks ago , i have a cutmaster 39 and a cutmaster 152. but i need a material contact sensor. wondering if any of you guys are run a thermal dynamics with you dhc2 with basic height control ? i have made a home made one but would like to get a good one if i can buy one for the units

thanks