Can anyone tell me where the control is in Mach 3 to cut exactly like the file is displayed in mach 3. Now when I cut the image is opposite or face down when it is finished cutting. I would like to find a way for the machine to cut exactly how I see the image on the screen. Any ideas?? Thanks.
Thread: Mach 3 Software Settings
Results 1 to 2 of 2
-
09-03-2012, 02:23 AM #1
Registered
- Join Date
- Aug 2011
- Posts
- 0
Mach 3 Software Settings
-
09-03-2012, 02:45 AM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
You have one or more axis setup backwards. If it's upside down, the Y axis is backwards. If it's flipped L to R, then the X is backwards. Sounds like you might have both backwards.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
Mach Settings
By ryguy_nayr in forum Mach Plasma / LaserReplies: 3Last Post: 01-11-2012, 06:10 PM -
mach 3 settings
By SatanKlawz in forum DIY CNC Router Table MachinesReplies: 1Last Post: 06-30-2010, 04:56 PM -
Mach Settings
By ltcjr71 in forum Charter Oak Automation Support ForumReplies: 8Last Post: 03-26-2010, 06:53 PM -
mach 3 settings
By najnielkp in forum Viper Servo drivesReplies: 4Last Post: 10-09-2007, 12:50 AM -
Mach 2 and settings
By tauscnc in forum Commercial CNC Wood RoutersReplies: 4Last Post: 05-25-2005, 03:05 PM
Posting Permissions
