I was recently given a 40w laser engraver that ive been refurbishing. I am trying to get moshidraw 2014 on my computer but am having trouble. I downloaded moshidraw 2014 and when i try it open the program i get the message "insert softkey! www.moshidraw.com" I cant figure out what to do from that point. the website is confusing and when i try to request the software through the website i get the message "bad request".
I'm so close to getting this thing going! I'm hoping to get some use out of it to afford a board upgrade.
THe machine was manufactured in 2011, not sure of which moshi board i have, i can post later if necessary, Is moshi 2014 compatible with my machine?
also, i am curious about the power needed to run the machine. The machine is 220v power. I have a 200w step up transformer and am wondering if that is enough or if I need more.
ive been having trouble finding good resources and tutorials for the chinese 40 w laser, if anyone knows of some good ones please post here.
Thanks!