We have a Conquest twin turn 65 with fanuc 18i-T control. We have added a float switch in the hydraulic tank and wired it into X17.0 input as shown on the prints. The input is OK but I don't have the Machine Builder Parameter list number to turn it on. Any help would be appreciated.
Thanks
Dave
Results 1 to 3 of 3
-
04-17-2014, 07:00 PM #1
Registered
- Join Date
- Mar 2013
- Posts
- 2
Hydraulic Resivoir level F/S Parameter
-
04-17-2014, 08:17 PM #2
Registered
- Join Date
- Jun 2004
- Posts
- 511
Re: Hydraulic Resivoir level F/S Parameter
If you are thinking that a Keep relay is needed to turn the switch on, ladder search al the loctions of your X bit and see if there are any K's in the same rung.
-
04-23-2014, 04:58 PM #3
Registered
- Join Date
- Mar 2013
- Posts
- 2
Re: Hydraulic Resivoir level F/S Parameter
Thanks for the reply. I looked in the program and the input needed was not there. But thanks for the direction anyway.
Dave
Reply With QuoteSimilar Threads
-
Need help in hydraulic oil
By keyancnc in forum Maintenance DIY DiscussionReplies: 2Last Post: 01-26-2012, 06:50 AM -
hydraulic help
By byoung0454 in forum Mechanical Calculations/Engineering DesignReplies: 4Last Post: 01-09-2008, 05:29 AM -
Which Hydraulic Oil do I use?????
By bherr in forum Bridgeport / Hardinge MillsReplies: 2Last Post: 06-13-2007, 02:01 AM
Tags for this Thread
Posting Permissions
